This universal throttle and cable assembly is for use with the full range of Mikuni VM and TM carbs up to 38mm.
Please Note: If wanting a shorter than 1050mm outer cable length including end fittings, please also add to cart the extra payment option and note your requested length in the message box next to your name details in the check out.
Our 7/8″ (22mm) Universal Throttle assembly is designed for use with all our VM and TM non-pump type carbs and especially the smaller carbs where the four cable connection position options on the throttle tube rotor enables you to take up the slack in cables with normally to long inner wires.
The throttle is CNC machined alloy with a black anodized finish.
The housing is 23mm wide and protruding tube length is 113mm for use with 110mm grips.
The exposed inner wire length is matched for use in Mikuni VM carbs using keyhole type cable attachment to the throttle valve. Use of this throttle and cable combo with OEM VM carb versions, fitted with a cable holder that is screwed to the slide, is restricted to carb sizes of 36mm and larger.
This cable comes with a 70 degree angled lower fitting into the top of your carb adjuster.
These premium grade cables use a Nylon lined outer housing. The Nylon liner inside the outer cable housing conduit is for reduced friction and heat resistance. All throttle cables must be lubricated during installation with cable lube or a very light oil such as 3 in 1 to avoid clogging. Besides the need to lubricate the inner wire in the housing, the cable end barrels at their pivot points should be lubricated with water proof grease. If you need to clean your cable which is particularly relevant for dirt bikes. We recommend using WD40 or a very light oil such as 3 in 1. This effectively washes away dirt from the cable, without clogging it.
This manufacturer has been making aftermarket throttles, cables and other products of quality for Mikunioz since the mid-1980’s.