Cable, Mikuni VM & TM carbs XV Virago Single Carb Conversion

$44.00 AUD

Only 34 left in stock


This Mikuni throttle cable is 950mm long (chrome elbow to elbow) and for use on Yamaha XV Virago’s when matching with Mikuni VM carbs ranging from 30mm up to 38mm & all TM non pump Mikuni carburetors 36mm thru to 38mm. The cable comes with a standard Yamaha XS, XV top fitting and a 90 degree lower fitting for screwing directly into the carb top for a low profile attachment and appearance. As the elbow threads directly into the screw on top of the VM carbs, to access the needle for clip adjustments etc, the carb needs to be removed and the whole body spun to undo the carb top.

The exposed inner wire length is matched for use in Mikuni VM carbs using keyhole type cable attachment to the throttle valve. If your motorcycle has an OEM Japanese Motorcycle VM carb version (which normally never run properly on 4 strokes), fitted with a cable holder that is screwed to the slide, this cables use is restricted to carb sizes of 36mm and larger.

These premium grade cables use a Nylon lined outer housing. The Nylon liner inside the outer cable housing conduit is for reduced friction and heat resistance.

All throttle cables must be lubricated during installation with cable lube or a very light oil such as 3 in 1 to avoid clogging. Besides the need to lubricate the inner wire in the housing, the cable end barrels at their pivot points should be lubricated with a light water proof grease.
If you need to clean your cable which is particularly relevant for dirt bikes. We recommend using WD40 or a very light oil such as 3 in 1. This effectively washes away dirt from the cable, without clogging it.


Additional information

Select Your Throttle Type

With Threaded adjuster, With Slot Only


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.