Mikuni TM42, HSR Push Pull Quick Action Throttle & Cables Combo

$155.00 AUD

In stock

SKU: PPQA42K Categories: , , ,


This Push Pull Quick Action throttle and cable assembly is for use on Mikuni TM42 / HSR Roller Slide Pumper Carbs with  7’8″ handlebars.

This premium grade throttle cable for use with Mikuni Carburetors has a Nylon lined outer housing. The Nylon liner inside the outer cable housing conduit is for reduced friction and heat resistance. The cables have mid-cable adjusters with 25mm of adjustment. The total length of the outer cable measuring from the end of the lower carb end ferrule to the elbow on the top curved plastic fittings is 1000mm (1 meter). On bikes with lower bars these will run nicely out around the speedo and the extra length then also allows for the fitment of 2″ risers. There is a small spring on the bottom of the return cable for setting a slight pre-load on the cable when the throttle is in the closed position, which then also controls any inner wire slack as the rotor moves under acceleration.

All throttle cables must be lubricated during installation with cable lube or a very light oil such as 3 in 1 to avoid clogging. Besides the need to lubricate the inner wire in the housing, the cable end barrels at their pivot points should be lubricated with water proof grease.
If you need to clean your cable which is particularly relevant for dirt bikes. We recommend using WD40 or a very light oil such as 3 in 1. This effectively washes away dirt from the cable, without clogging it.

Our 7/8″ (22mm) Push Pull Quick Action Competition Throttle assembly is designed with the ideal 1/4turn ratio for use on Mikuni TM Pumper carburetors. It has a black epoxy finished die-cast aluminum housing, nylon throttle sleeve.

This manufacturer has been making aftermarket throttles, cables and other products of quality for Mikunioz since the mid-1980’s.


There are no reviews yet.

Be the first to review “Mikuni TM42, HSR Push Pull Quick Action Throttle & Cables Combo”

Your email address will not be published. Required fields are marked *