Outlet Adapter Sleeve for Increasing Mikuni TM24 31mm spigot to 35mm

$28.60 AUD

In stock

Description

This Mikuni outlet adapter sleeve is for increasing the spigot diameter from 31mm to 35mm on Mikuni TM24 Flatslide carbs. This then allows the for a correct mating fit when using the range of our engine mounting flanges.

This  adapter sleeve has been designed and manufactured for a good interference fit over the Mikuni carburetor spigot.

This spigot must be installed by a competent person. It is recommended to carefully remove with a fine file any protruding castings found on some carburetor spigots before pressing on the new sleeve.  When pressing on the sleeve we recommend the use of a high strength 620 Loctite retaining compound or if a not so tight interference fit use Loctite 660 or a high strength two pack epoxy. The adhesive besides helping bond both items together will fill and seal any imperfections found on some carburetor spigots and also acts a a slight lubricant for the fitment.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.