Throttle Cable end fittings, Choose from the sales drop down list

$1.10 AUD$13.00 AUD



Select your required fitting from the sales drop down list.

A good quality liquid flux such as Bakers must be used to prep the inner wire and fitting before soldering. If an old used and or oiled cable, pre-clean using acetone. On galvanized wire ( do a magnet test) use a tin/lead type solder, the higher the tin content the better, preferably 60/40. The better you can birds nest the cable end before soldering will help guarantee a lifetime connection.

Additional information

Select Your Fitting

Inline Adj, Top Adj 10.1mm, Ball 4.5mm Dia, Ball 5mm Dia, Barrel 6×4, Barrel 6×5, Barrel 6×10, Carb Adj Top Cap, Ferrule 5mm ID, Ferrule 6mm ID, Nipple 3x4mm, Roadbike top 10mm fitting, Roadbike top 12mm fitting, Throttle Boot VMX, Throttlp Boot MX 9mm, MX Adj & Boot, Push Pull Throttle Boot, Yam XS XV Top Fitting


There are no reviews yet.

Be the first to review “Throttle Cable end fittings, Choose from the sales drop down list”

Your email address will not be published. Required fields are marked *