VM28/511 Mikuni Needle and Seat- Viton Tip

$44.00 AUD

(Please identify your needle & seat assy and choose carefully as these are non-returnable items due to the undetectable risk of customer tampering)

SKU: N/A Category:

Description

Choose the top flow hole diameter from the sales drop down list. This size is an actual mm measurement of the diameter of the hole itself and usually is stamped on the end of the seat. If converting from gravity feed fuel to pumped, down sizing this hole size eliminates the risk of seat pop off and flooding. For methanol go as big as you can.

The 12.5mm measurement between the seating shoulder on the seat and the top of the pin is the important one if the thread is also correct. If the 12.5mm is too short, threaded seats can be set at correct heights using shiming washers.

Some seats may not be found in our listings and these will only be available from the OEM motorcycle manufacturer for whom they will have been specially made. If unsure call or email.

The clips on the needles are there for ease of assembly and have no bearing on the actual function. Some seats may or may not have an adapter on top for fitting a screen filter which can easily be replace by using an inline filter on the main supply hose.

Additional information

Feed Hole Size

1.5, 1.8, 2.0, 2.5

Reviews

There are no reviews yet.

Be the first to review “VM28/511 Mikuni Needle and Seat- Viton Tip”

Your email address will not be published. Required fields are marked *